Minolta Scanner Mode Manual de usuario descargar pdf (Pagina 5)

Raindrop Geomagic, Inc. Minolta Scanner Plugin Geomagic Studio and Qualify

Document version A page 5

• Auto Focus checkbox - Specifies whether the camera uses automatic

focusing. When Auto Focus is turned off, use the Distance control

to focus manually.

• Distance thumbwheel (500 to 3000 millimeters; applicable when

Auto Focus is Off) - specifies the distance between the lens and

the focal point.

• Auto Intensity checkbox (default On) - specifies that the beam

intensity be selected by software based on reflectivity of the object.

When deactivated, set Laser Power and Gain by hand.

• Laser Power integer field (0 to 100; applicable when Auto Inten-

sity is off) - controls the intensity of the laser beam. Higher inten-

sity is suitable for darker colors, lower intensity for lighter colors.

• Gain integer field (0 to 100; applicable when Auto Intensity is off

and Laser Power is at 100) - controls the intensity of the CCD

gain. Use CCD gain only when Laser Power of 100 is insufficient

because the object reflects light, transmits light, or has low reflec-

tance for red and similar colors.

• Variable Distance Mode checkbox -

• No. of Scans integer field (2 or 3) -

• Distance Increment decimal field (0 to 1000 mm) -

• Turntable group (only when a turntable is installed) -

• Current Position decimal field (0.0 to 360.0) - is an indicator and

control of the current position of the turntable with respect to the

zero position.

• Rotation Step field (1 to 359; default 45; applicable when Scan

Mode is MultiShot or Continuous) - specifies the number of degrees

of rotation of the turntable per click of the Next button.

• Scan Mode (Single, Multishot, Continuous):

• Single - This mode can be used to take individual shots, and is the

only mode available when the turntable is disabled.

• MultiShot - causes the turntable to rotate by Rotation Step

degrees and a new scan to take place every time the user presses

Next. During a MultiShot process, click Next

to move on to the

next scan, or adjust the parameters and click Scan to re-scan the

object at its current position.

• Continuous - is similar to MultiShot mode except that scanning

and rotation are non-stop (without pressing Next) until the Cur-

rent Position reaches 360 degrees or less (until Rotation Step

would cause Current Position to exceed 360 degrees).

• Reset Zero button - defines the current position of the turntable as

the home (zero) position.

• Calibrate Axis button - prompts the user to install the black and

white axis calibration “chart” onto the turntable, performs the cali-

bration, and displays the turntable axis in the Viewing Area.

• Advanced Options button - activates the following controls:

• Configure group - describes the hardware setup:

1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios

Minolta Scanner Mode Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Escáner Máxima Transparencia Adaptadores Minolta Scanner Mode