Minolta magicolor 2210 Guía de instalación descargar pdf (Pagina 34)

Installing Printer Drivers and Software30

English

Crown port that was added during the Crown Print Monitor

installation.

Choose OK to close the Printer Properties window.

Close the Printers window.

For additional information about the Crown Print Monitor, see the

Crown Print Monitor Administrator’s Guide (in PDF format on the

Software Utilities

CD-ROM). For information about the print monitor

that comes with Microsoft Windows 2000, see your Windows

documentation.

Installing Macintosh Drivers and Utilities

EtherTalk Interface Configuration

You can configure your MINOLTA-QMS print system by several different

methods.

This section briefly describes the configuration procedure for the printer

interface. You can make these configuration changes through any of the

following means:

„

Printer control panel

„

Print Utility for Macintosh

„

Remote Console

„

CrownView

When your printer boots up, it will find a default zone. If your network has

more than one zone, use the Administration/Communications/Resident NIC/

CrownNet/EtherTalk/Zone Name/Zone Part 1 and Zone Part 2 menus to enter

the name of the zone to which the printer is attached.

The two Zone Part x menus allow you to identify 1 zone with a

name up to 32 characters long. (Up to 16 characters can be

entered in each of the two menus). You cannot use these two

menus to identify two zones. Trailing spaces are not considered

part of the zone name. All standard printable ASCII characters are

valid except the @ and ' symbols. The names are case sensitive.

EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 47 48

Sin comentarios

Minolta magicolor 2210 Guía de instalación Pagina 34