Minolta PI4700E Manual de usuario descargar pdf (Pagina 13)

Di470

* Trademark ownership information

Solution ID

Solution Usage

TAUS0636118EN*

Description

Parts listing for the punch unit of the FN-105/FN-106.

Solution

Please refer to bulletin 3627 for a list of available parts for the punch unit. Please note that in most cases the punch unit must be replaced as a complete

assembly. The part number for the punch assembly is 3643-4051-01.

Solution ID

Solution Usage

TAUS0636363EN*

Description

Paper jams from both drawers intermittently at first, then more frequently, but feeds normally through the manual feed. The jam occurs at the turn from the

vertical transport where it meets the horizontal transport area.

Solution

CAUSE:

Dirty bushing.

SOLUTION:

Check the bushing shown as index 16 in figure 15 . Clean the shaft and bushing and lubricate lightly.

Solution ID

Solution Usage

TAUS0636369EN*

Description

C-1083 is indicated on the machine display. The service code is not specifically mentioned in the manual, but it mentions possible problems with the Image

Control Board, Memory Board, or Hard Disk.

Solution

Cause: An incorrect indication of C-1083 could be caused by a firmware bug.

Solution: Please upgrade to the current firmware on bulletin 4268a

Solution ID

Solution Usage

TAUS0636371EN*

Description

C-0540 is displayed intermittently. The thermistors and fuser lamps check out fine.

Solution

CAUSE: Original firmware versions did not allow time enough for the fuser to reach the correct temperature before displaying the error code.

SOLUTION: Timing has been corrected with the latest firmware. Verify and upgrade if necessary the firmware level to the latest version.

Solution ID

Solution Usage

TAUS0636621EN*

Description

Why print jobs do not print from Macintosh* OS 10.2.4 when the Copy Track feature is enabled.

Solution

Please refer to Bulletin 4388 for information about using the Macintosh OS X PPD Fiery* Job Notes feature on a computer running Macintosh OS version

10.2.4 or later.

Note: To view the above PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:

[[http://www.adobe.com/products/acrobat/readstep2.html| URL http://www.adobe.com/products/acrobat/readstep2.html]]

* Trademark ownership information

Solution ID

Solution Usage

TAUS0637079EN*

Description

Why is the bypass tray sometimes not available for walk-up copying when jobs are in the lock job queue?

Solution

This is a limitation of the copier/printer when using lock job or reserve copy functions. A message is displayed when a piece of paper is inserted in the bypass

to alert the user to the fact that this feature is unavailable. To utilize the bypass tray, any lock jobs must first be printed and all reserved jobs cleared.