Minolta PI4700E Manual de usuario descargar pdf (Pagina 22)

Di470

Part number for the clutch in the punch unit. The Parts Manual indicates that only the whole unit is available.

Solution

A part number for the Clutch (p/n 4470-7801-01) has been added due to a request from the field.

Note: See Technical Bulletin 3853 for details.

Solution ID

Solution Usage

TAUS0644679EN*

Description

Power requirements, BTU data, warm up time, and first copy time measurements.

Solution

Please click here to see the data for this machine.

Note: To view the above PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:

[[http://www.adobe.com/products/acrobat/readstep2.html| URL http://www.adobe.com/products/acrobat/readstep2.html]]

* Trademark ownership information

Solution ID

Solution Usage

TAUS0644689EN*

Description

The rollers in the LCT are making a loud rubbing noise. After they are cleaned the noise stops but the sound will return within a few days.

Solution

CAUSE: The guide plate in the PF-115 tends to wear, causing parts to rub in the paper feed section. This may cause a noise to be made when the PF-115 is

operating.

SOLUTION: Please see service bulletin 3825 . In addition, the paper feed rollers should be replaced.

Solution ID

Solution Usage

TAUS0644710EN*

Description

When copying in duplex mode from the EDH, the image on the second side is rotated.

Solution

CAUSE: Incorrect setting.

SOLUTION: On the front panel, press Orig. - Copy, then press Margin and change the position setting to the one with the margin on top (on the right). It is

not necessary to change the margin width. Click here to see what the control panel screen looks like.

Note:

To view the above PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:

[[http://www.adobe.com/products/acrobat/readstep2.html| URL http://www.adobe.com/products/acrobat/readstep2.html]]

* Trademark ownership information

Solution ID

Solution Usage

TAUS0644715EN*

Description

Can all print jobs be forced to the same output tray?

Solution

There is no way to send all jobs to the upper (non-sort) tray, due to mechanical contstraints. For example, with the FN-3 (or FN-5) and jobs with stapling or

folding, it cannot come out on the top tray, as that is not possible with the paper path used by the stapling mechanism. However, all jobs can be forced to the

lower tray with a User's Choice setting that is available when running the current firmware in the copier. On tab 6, press "Priority Offset Tray" and select

"Bottom Tray."

Solution ID

Solution Usage

TAUS0644738EN*

Description

The machine displays the code C0F24.

Solution

CAUSE: Dirty or malfunctioning AIDC sensor.

SOLUTION: Check to ensure that the AIDC sensor is clean and that the connections are good. If the code persists, replace the AIDC sensor. For additional