Di470
Description
The counters for the Di470 are not displayed in PageScope Net Care. Can this be corrected?
Solution
The firmware of the copier must be updated to the latest version. The unit will display the following counts when using PageScope Net Care version 5.01.20,
Total Count, Duplex Count, Total Jam Count, and Count by Paper Size.
Firmware vers.MSC IC353B 4028-F0G0-32-00 contains support for PageScope NetCare.
Solution ID
0
Solution Usage
TAUS0644577EN*
Description
The copier will not turn on after the firmware update procedure has been carried out. After switching on the copier the LED's of the start button and HDD light
up momentarily.
Solution
CAUSE: This can occur if the main switch is turned off or there is a loss of power to the unit while data is downloading from the flash card.
SOLUTION: Remove all accessories from copier. If a print controller is attached to the ECC board, disconnect it. Having a controller attached at the time the
copier is flashed may cause the copier to lock up, and give the appearance of a dead copier. If this does not resolve the problem, try the procedure below to
recover the firmware download of the PWB-A board:
1. Switch off the main switch and unplug the main power cord from the power outlet.
2. Remove all connectors from the PWB-A board except the connector PJ1, PJ14 and PJ15.
3. Put the flash memory card, programmed with the correct printer firmware, in the socket (CN 1) of the PWB-A board.
4. Connect the main power cord to the machine.
5. Turn on the main switch.
6. The rewriting sequence starts automatically.
7. Don't touch the machine until LD3 and LD 4 are on steady and no longer blinking.
8. When LD3 and LD4 are on disconnect the main power cord.
9. Remove the Flash memory card from the PWB-A board.
10. Reinstall all the connectors on the PWB-A board you had removed in step 2.
11. Turn off the main switch.
12. Plug the power cord into the power outlet.
13. Turn on the main switch.
14. Check printer firmware version in Tech. Rep. Mode.
Note: If problems with firmware updates are encountered when flashing boards simultaneously, it is recommended that they be flashed separately.
Bulletin 3428 .
Solution ID
0
Solution Usage
TAUS0644623EN*
Description
How to clear an M-6 (M6) code.
Solution
M-6 indicates that the exposure lamp needs adjustment or replacement. To clear the code, perform the following:
1. Enter the Tech Rep mode.
2. Enter I.R. & EDH Check.
3. Then go to Function I.R.
4. Run the Exp. Lamp Check.
5. Then run the Address Adjust.
If the code persists, change the exposure lamp.
Solution ID
0
Solution Usage
TAUS0644632EN*
Description
The code C11FE is displayed when the first non-sort copy enters the finisher tray after the main switch is turned on.
Solution
CAUSE: Firmware.
SOLUTION: The firmware of the FN-503 has been modified to correct the code from being displayed on the copier. Please see Bulletin 3395A for further
details and firmware download.
Solution ID
0
Solution Usage
TAUS0644641EN*
Description
21
Copyright 2007, Konica Minolta Business Solutions U.S.A., I nc.
September 2007
(12 paginas)
(162 paginas)
(276 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales