
Di470
Solution ID
0
Solution Usage
TAUS0640101EN*
Description
Does the machine ship with developer?
Solution
Developer is not included with the Di470. Here is a list of supplies for the Di470:
ITEM# ITEM
4002029101 Photoconductor
4448101 Staple Cartridge (for FN3, FN5, ST210, ST212, ST213, ST1000)
4448121 Staple Cartridge MS-5C (for FN100, FN102, FN104, FN500, FN502, FN503, FN504, FN112, FN6, FN7, FN9, FN120, FN10 and FN121)
4623361 MS-5D Staples (for FN105, FN107, FN109, FN113, FN117, FN122 and FS601)
4623371 MS-3D Staples (for FN116, FN110, FN106 and FS501)
7660016001 160K PM Parts Kit
7660024001 240K PM Parts Kit
7660048001 480K PM Parts Kit
7660096001 960K PM Parts Kit
8936902 Toner 502A
8936912 Starter 502
Solution ID
0
Solution Usage
TAUS0640575EN*
Description
Service code C-0D50 (Duplex Horizontal Transport Motor M131 failure) is displayed at start up.
Solution
Check for continuity between the wires of the Duplex Horizontal Transport Motor (M131) and the PF-115 main board (PWB-A). If there is continuity, replace
the Duplex Horizontal Transport Motor (part number 9314-2911-02).
Solution ID
0
Solution Usage
TAUS0640959EN*
Description
Information for parts number (Stapler unit/finisher tray).
Solution
See KOM050121 for details.
Note: To view the above PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:
[[http://www.adobe.com/products/acrobat/readstep2.html| URL http://www.adobe.com/products/acrobat/readstep2.html]]
* Trademark ownership information
Solution ID
0
Solution Usage
TAUS0641303EN*
Description
Thermostat replacement precautions for all models using Faston Terminals.
Solution
CAUSE: Damage to the Faston terminal when replacing the thermostat to the Faston terminal can result in the generation of heat and cause the plastic
insulating material around the terminal to melt.
SOLUTION: See Bulletin Number 5005 for details.
Note: To view the PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:
[[http://www.adobe.com/products/acrobat/readstep2.html| URL http://www.adobe.com/products/acrobat/readstep2.html]]
* Trademark ownership information
Solution ID
0
Solution Usage
TAUS0641735EN*
Description
Peripheral mode and controller type settings for the Pi4700e.
Solution
On the Di470 the controller type must be set to 6 for the Pi4700e. With controller system 1 on the Pi4700e, the peripheral mode must be set to 1. With
controller system 3 or higher, the peripheral mode must be set to 2 if the hard disk is installed or to 3 if the hard disk is not installed.
Notes:
1. For details on Pi4700e version 4 please see bulletin 4796 .
16
Copyright 2007, Konica Minolta Business Solutions U.S.A., I nc.
September 2007
Comentarios a estos manuales