Minolta PI4700E Manual de usuario descargar pdf (Pagina 15)

Di470

[[http://www.adobe.com/products/acrobat/readstep2.html| URL http://www.adobe.com/products/acrobat/readstep2.html]]

* Trademark ownership information

Solution ID

Solution Usage

TAUS0637787EN*

Description

A newly installed Pi4700e does not produce a configuration page after the copier is powered ON.

Solution

PROBABLE CAUSES:

1. Incorrect controller type and/or peripheral mode has been set.

Please make sure the controller type is set to 6 and the periperal mode has been set as follows:

Pi4700e with system version 1 requires peripheral mode 1.

Pi4700e with system version 3 or higher and optional hard disk (in the controller) requires peripheral mode 2.

Pi4700e with system version 3 or higher and no hard disk installed (in the controller) requires peripheral mode 3.

2. Problem with the NIC.

Please reset the NIC by performing the following:

a. Disconnect the power from the machine.

b. Move the jumper provided at pins "OP2" on the NIC card one pin to the left, toward the letters "FACT."

c. Turn on the power and allow the controller and NIC to come to their ready states.

d. Disconnect the power and re-position the jumper back to its original position.

3. Problem with the controller board.

Please reset the controller by performing the following:

a. Disconnect the power from the machine.

b. Change DIP switch 1, bit 4 to ON.

c. Turn on the power and allow the controller to come to its ready state (allow 5-10 minutes).

d. Disconnect the power and change DIP switch 1, bit 4 back to the OFF position.

Solution ID

Solution Usage

TAUS0638394EN*

Description

Part number for the clutch in the punch unit of the FN-5.

Solution

The part number of the clutch is 4470-7801-01. Please refer to bulletin 3853 .

Solution ID

Solution Usage

TAUS0639253EN*

Description

Duplex jamming when making 2-sided copies.

Solution

CAUSE: Random operation of M10. Bushings were contaminated because of poor environment (i.e., cigarette smoke, dust).

SOLUTION: Clean and lubricate turnover and exit bushings.

Solution ID

Solution Usage

TAUS0639994EN*

Description

C-0F33 code and the steps in the Troubleshooting section of the manual do not resolve the problem.

Solution

CAUSE: Incorrect settings.

SOLUTION: Check to make sure that the ATDC value noted after running F8 was entered as the "set" value in the Adjust Mode. If the ATDC "set" value was

correct, check the connections between the PWB-A and the ATDC.

To check the ATDC "set" value, follow the procedure below:

1. Enter the Tech Rep. mode.

2. Press the stop key and then the start key.

3. Select printer.

4. Select ATDC reference value. The current value should be close to 5V DC and the set value should be the same voltage setting as the current. If the

value is found to be at "0V" the ATDC setting was not set properly when new developer was installed.

Note: When installing new developer, make sure that the toner hopper and sub hopper are empty. If not, extra toner may be added at the time the ATDC

reference value is set (during F8 process). This will cause light copies.